Chapter 9
Monitor Performance
•
Click Refresh. Optical power statistics for the selected port appear.
Step 4
Click the Opt. Ampli. Line tab.
Step 5
Click Refresh. Optical power statistics for the optical amplifier output port (COM TX, Port 02 for the
Step 6
OPT-PRE card, and Line TX, Port 06 for the OPT-BST card) appear.
Return to your originating procedure (NTP).
Step 7
DLP-G141 View Optical Power Statistics for 32MUX-O, 32-WSS, 32-DMX-O, and
32DMX Cards
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
In node view, double-click the 32MUX-O, 32WSS, 32-DMX-O, or 32DMX card where you want to view
Step 1
PM counts. The card view appears.
Click the Performance > Optical Chn tabs
Step 2
September 2005
DLP-G141 View Optical Power Statistics for 32MUX-O, 32-WSS, 32-DMX-O, and 32DMX Cards
–
4—DC TX
For the OPT-BST card, the following ports are available to view:
1—COM RX
–
2—COM TX
–
3—OSC RX
–
4—OSC TX
–
5—Line RX
–
This task enables you to view optical power statistics for a 32MUX-O,
32WSS, 32-DMX-O, or 32DMX card.
None
DLP-G46 Log into CTC, page 2-25
As needed
Onsite or remote
Retrieve or higher
(Figure 9-3 on page
Cisco ONS 15454 DWDM Installation and Operations Guide, R6.0
9-14).
9-13