Utilization Tab On The Card View Performance Window - Cisco ONS 15454 DWDM Installation And Operation Manual

Chapter 9 Monitor Performance
Figure 9-11
Card View
Performance tab
Utilization tab
Payload PM tab
Click Refresh. PM utilization values appear for each port on the card.
Step 3
View the appropriate row for the port you want to monitor.
Step 4
The transmit (Tx) and receive (Rx) bandwidth utilization values for the previous time intervals appear
Step 5
in the Prev-n columns. For PM parameter definitions, refer to the "Performance Monitoring" chapter in
the Cisco ONS 15454 Troubleshooting Guide or the Cisco ONS 15454 SDH Troubleshooting Guide.
Note
Return to your originating procedure (NTP).
Step 6
September 2005

Utilization Tab on the Card View Performance Window

Interval Refresh Help
menu button button
To refresh, reset, or clear PM counts, see the
page 9-2.
DLP-G150 View Payload Utilization PM Parameters
"NTP-G73 Change the PM Display" procedure on
Cisco ONS 15454 DWDM Installation and Operations Guide, R6.0
9-29