Figure 3-2 Selecting The Ip Address Option; Figure 3-3 Changing The Ip Address; Dlp- G57 Set The Ip Address, Default Router, And Network Mask Using The Lcd - Cisco ONS 15454 DWDM Installation And Operation Manual

Chapter 3 Turn Up a Node
DLP-G57 Set the IP Address, Default Router, and Network Mask Using the LCD
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
You cannot perform this task if the LCD IP Display field on the node view Provisioning > Network tab
Note
is set to Display Only or Suppress Display. See the
to view or change the LCD IP Display field.
Note The LCD reverts to normal display mode after 5 seconds of button inactivity.
On the ONS 15454 front panel, repeatedly press the Slot button until Node appears on the LCD.
Step 1
Repeatedly press the Port button until the following displays:
Step 2
•
•
•
Figure 3-2
Press the Status button to display the node IP address
Step 3
default router IP address.
Figure 3-3
Push the Slot button to move to the digit of the IP address or subnet mask that you want to change. The
Step 4
selected digit flashes.
September 2005
This task changes the ONS 15454 IP address, default router, and network
mask using the LCD on the fan-tray assembly. Use this task if you cannot
log into CTC.
None
DLP-G33 Install the TCC2 or TCC2P Card, page 1-72
As needed
Onsite
None
To change the node IP address, Status=IpAddress
To change the node network mask, Status=Net Mask
To change the default router IP address, Status=Default Rtr
Selecting the IP Address Option
Slot Status
FAN FAIL CRIT MAJ
Changing the IP Address
Slot Status
FAN FAIL CRIT MAJ
DLP-G57 Set the IP Address, Default Router, and Network Mask Using the LCD
"DLP-G56 Provision IP Settings" task on page 3-12
(Figure
Port
Slot-0
Status=IpAddress
MIN
(Figure
Port
172.020.214.107
<Next Done
MIN
Cisco ONS 15454 DWDM Installation and Operations Guide, R6.0
3-2)
3-3), the node subnet mask length, or the
Mod>
3-15