Table 11-1 Oscm And Osc-Csm Card Oc-3 Settings; Dlp- G199 Change The Oscm And Osc-Csm Optical Service Channel Settings - Cisco ONS 15454 DWDM Installation And Operation Manual

Chapter 11 Change DWDM Card Settings
Table 11-1 OSCM and OSC-CSM Card OC-3 Settings
Parameter Description
Port # Displays the port number.
Port Name Provides the ability to assign the specified port
a name.
SF BER Sets the signal fail bit error rate.
SD BER Sets the signal degrade bit error rate.
Provides (Display only) If checked, the card is
Synch provisioned as a network element (NE) timing
reference.
SynMsgIn Enables synchronization status messages
(SSM) on the S1 byte, which allow the node to
choose the best timing source.
Send Do Not When checked, sends a Do Not Use for
Use Synchronization (DUS) message on the S1
byte.
PJSTSMon # (Display only) Sets the STS that will be used
for pointer justification. If set to 0, no STS is
monitored. Only one STS can be monitored on
each OC-N port.
September 2005
DLP-G199 Change the OSCM and OSC-CSM Optical Service Channel Settings
Options
Display only
User-defined. Name can be up to 32 alphanumeric/special
characters. Blank by default.
See the "DLP-G104 Assign a Name to a Port" task on
page 7-10.
From the drop-down list, choose one of the following:
1E-3
•
1E-4
•
1E-5
•
From the drop-down list, choose one of the following:
• 1E-5
• 1E-6
• 1E-7
1E-8
•
1E-9
•
Checked
•
Unchecked
•
Checked
•
Unchecked
•
Checked
•
• Unchecked
From the drop-down list, choose one of the following:
• On
Off
•
Cisco ONS 15454 DWDM Installation and Operations Guide, R6.0
11-3