Dlp- G56 Provision Ip Settings - Cisco ONS 15454 DWDM Installation And Operation Manual

DLP-G56 Provision IP Settings
DLP-G56 Provision IP Settings
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Caution All network changes should be approved by your network (or LAN) administrator.
In node view, click the Provisioning > Network > General tabs.
Step 1
Complete the following information in the fields listed:
Step 2
•
•
•
•
•
•
Cisco ONS 15454 DWDM Installation and Operations Guide, R6.0
3-12
This task provisions IP settings, which includes the IP address, default
router, DHCP access, firewall access, and SOCKS proxy server settings for
an ONS 15454 node.
None
DLP-G46 Log into CTC, page 2-25
Required
Onsite or remote
Superuser
IP Address—Type the IP address assigned to the ONS 15454 node.
Suppress CTC IP Display—Check this check box if you want to prevent the node IP address from
being displayed in CTC to users with Provisioning, Maintenance, or Retrieve security levels. (The
IP address suppression is not applied to users with Superuser security level.)
LCD IP Display—Choose one of the following:
Allow Configuration—Displays the node IP address on the LCD and allows users to change the
–
IP settings using the LCD. This option enables the
Router, and Network Mask Using the LCD" task on page
Display Only—Displays the node IP address on the LCD but does not allow users to change the
–
IP address using the LCD.
Suppress Display—Suppresses the node IP address display on the LCD.
–
Default Router—If the ONS 15454 is connected to a LAN, enter the IP address of the default router.
The default router forwards packets to network devices that the ONS 15454 cannot directly access.
This field is ignored if any of the following are true:
The ONS 15454 is not connected to a LAN.
–
SOCKS proxy server is enabled and the ONS 15454 is provisioned as an end network element
–
(ENE).
OSPF is enabled on both the ONS 15454 and the LAN where the ONS 15454 is connected.
–
Forward DHCP Request To—Check this check box to enable DHCP. Also, enter the DHCP server
IP address in the Request To field. Unchecked is the default. If you will enable any of the gateway
settings to implement the ONS 15454 SOCKS proxy server features, leave this field blank.
If you enable DHCP, computers connected to an ONS 15454 node can obtain temporary IP
Note
addresses from an external DHCP server. The ONS 15454 only forwards DHCP requests; it
does not act as a DHCP server.
MAC Address—(Display only) Displays the ONS 15454 IEEE 802 MAC address.
Chapter 3
"DLP-G57 Set the IP Address, Default
3-15.
Turn Up a Node
September 2005