Dlp- G235 Change Card Settings For Mxp_Mr_2.5G And Mxpp_Mr_2.5G Cards - Cisco ONS 15454 DWDM Installation And Operation Manual

DLP-G235 Change Card Settings for MXP_MR_2.5G and MXPP_MR_2.5G Cards
Stop. You have completed this procedure.
DLP-G235 Change Card Settings for MXP_MR_2.5G and MXPP_MR_2.5G Cards
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Card settings can be changed only if the facilities are out of service (OOS).
Note
In node view, double-click the MXP_MR_2.5G or MXPP_MR_2.5G card where you want to change the
Step 1
card settings.
Click the Provisioning > Card tabs.
Step 2
Modify any of the settings described in
Step 3
Table 5-41
Parameter
Card Mode
Wavelength
Click Apply.
Step 4
Return to your originating procedure (NTP).
Step 5
Cisco ONS 15454 DWDM Installation and Operations Guide, R6.0
5-66
This task changes the card settings for MXP_MR_2.5G and
MXPP_MR_2.5G muxponder cards.
None
DLP-G46 Log into CTC, page 2-25
As needed
Onsite or remote
Provisioning or higher
Table
MXP_MR_2.5G and MXPP_MR_2.5G Muxponder Card Settings
Description
Sets the mode of operation (option only
supported for SONET/SDH payloads).
This setting is not currently
Note
supported. The only option
available currently is FC-GE.
Sets the wavelength of the DWDM side
optical transmitter.
Chapter 5 Provision Transponder and Muxponder Cards
5-41.
Options
FC-GE
•
First Tunable Wavelength
•
Further wavelengths in 100-GHz ITU
•
spacing
Supported wavelengths are in white
•
and marked by asterisks (**);
unsupported wavelengths are gray.
The four available wavelengths
Note
are listed in the Card Parameters
section of the window and also in
the Maintenance > Info tab.
September 2005