Cisco ONS 15454 DWDM Installation And Operation Manual page 586

NTP-G131 Convert DWDM Nodes to Hybrid Nodes
Note
To modify the OSC-CSM card line direction, double-click the OSC-CSM card in node view. The
a.
card view appears.
Click the Provisioning > Optical Line > Parameter tabs.
b.
In the Port 2 line, click the Line Direction drop-down list and choose East to West.
c.
Click Apply.
d.
Calculate default connections using WDM-ANS:
Step 13
Click the CTC up arrow to get back to node view.
a.
In node view, click the Provisioning > WDM-ANS > Connections tabs.
a.
Click the Calculate Connections button.
b.
Connect the cables from the OSC-CSM LINE ports to the OPT-BST amplifier OSC ports. Follow the
Step 14
recommended connections that were automatically calculated in the Connections tab as described in
Step 13.
Launch ANS port regulation:
Step 15
In node view, click the Provisioning > WDM-ANS > Port Status tabs.
a.
Click the Launch ANS button.
b.
In the Link Status column, the ports change to Regulated.
c.
Step 16 Create OSC terminations starting from the OSC-CSM card. See the
Terminations" task on page
(Optional) If you want to set up timing on the OSC-CSM card, create the timing source:
Step 17
In node view, click the Provisioning > Timing tabs.
a.
b. Scroll down to the Reference Lists area.
In the NE Reference column, select Internal Clock from the drop-down list for all entries where the
c.
selected Clock Source is the OSC-CSM that you are adding.
Click Apply.
d.
Step 18 (Optional) Complete the
Repeat Steps
Step 19
If you are installing cross-connect cards, refer to the Cisco ONS 15454 Procedure Guide or the
Step 20
Cisco ONS 15454 SDH Procedure Guide for instructions.
Stop. You have completed this procedure.
Cisco ONS 15454 DWDM Installation and Operations Guide, R6.0
10-60
The Cisco MetroPlanner configuration file will label the OSC-CSM card as east even if it is
installed in the west side of the node.
3-84.
"NTP-G60 Create Overhead Circuits" procedure on page
3 through 18 for each OSCM card you are replacing in the node.
Chapter 10 Manage the Node
"NTP-G38 Provision OSC
7-13.
September 2005