Dlp- G110 Create A User Data Channel Circuit - Cisco ONS 15454 DWDM Installation And Operation Manual

DLP-G110 Create a User Data Channel Circuit
•
Click Next.
Step 6
In the Circuit Destination area, complete the following:
Step 7
•
•
•
Click Finish.
Step 8
Return to your originating procedure (NTP).
Step 9
DLP-G110 Create a User Data Channel Circuit
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
In network view, click the Provisioning > Overhead Circuits tabs.
Step 1
Click Create.
Step 2
In the Overhead Circuit Creation dialog box, complete the following fields in the Circuit Attributes area:
Step 3
•
•
Step 4 Click Next.
In the Circuit Source area, complete the following:
Step 5
•
•
•
Click Next.
Step 6
In the Circuit Destination area, complete the following:
Step 7
•
•
•
Cisco ONS 15454 DWDM Installation and Operations Guide, R6.0
7-20
Port—If applicable, choose the source port.
Node—Choose the destination node.
Slot—Choose the destination slot.
Port—If applicable, choose the destination port.
This task creates a UDC circuit on the ONS 15454. A UDC circuit allows
you to create a dedicated data channel between nodes.
OSCM, OSC-CSM, MXPP_MR_2.5G, or MXP_MR_2.5G must be
installed.
DLP-G46 Log into CTC, page 2-25
As needed
Onsite or remote
Provisioning or higher
Name—Assign a name to the circuit. The name can be alphanumeric and up to 48 characters
(including spaces).
Type—Choose either User Data-F1 or User Data D-4-D-12 from the drop-down list.
(User Data D-4-D-12 is not available if the ONS 15454 is provisioned for DWDM.)
Node—Choose the source node.
Slot—Choose the source slot.
Port—If applicable, choose the source port.
Node—Choose the destination node.
Slot—Choose the destination slot.
Port—If applicable, choose the destination port.
Chapter 7 Create Channels and Circuits
September 2005