Dlp- G25 Install Lan Wires On The Backplane (Ansi Only) - Cisco ONS 15454 DWDM Installation And Operation Manual

DLP-G25 Install LAN Wires on the Backplane (ANSI Only)
Table 1-6
BITS Pin
A1
B1
Note
Return to your originating procedure (NTP).
Step 2
DLP-G25 Install LAN Wires on the Backplane (ANSI Only)
Purpose
Tools/Equipment
Prerequisite Procedures None
Required/As Needed
Onsite/Remote
Security Level
Rather than using the LAN wires, you can use the LAN connection port on the TCC2/TCC2P if
Note
preferred. Use either the backplane connection or the TCC2/TCC2P front connection. You cannot use
the LAN backplane pins and the LAN connection port on the TCC2/TCC2P simultaneously; however, it
is possible for you to make a direct connection from a computer to the LAN connection port on the
TCC2/TCC2P while the LAN backplane pins are in use as long as the computer that is connected directly
to the TCC2/TCC2P is not connected to a LAN.
Using #22 or #24 AWG (0.51 mm² or 0.64 mm²) wire or CAT-5 UTP Ethernet cable, wrap the wires on
Step 1
the appropriate wire-wrap pins according to local site practice.
Caution Cross talk might result if both receive (Rx) and transmit (Tx) pins connect on the same twisted pair of
wires from the CAT-5 cable. The two Tx pins need to be on one twisted pair, and the two Rx pins need
to be on another twisted pair.
A frame ground pin is located beneath each pin field (FG2 for the LAN pin field). Wrap the ground shield
of the LAN interface cable to the frame ground pin.
Cisco ONS 15454 DWDM Installation and Operations Guide, R6.0
1-56
External Timing Pin Assignments for BITS (continued)
Tip/Ring CTC/TL1 Name Function
ring BITS-2
tip BITS-2
For more detailed information about timing, see
system timing, see the "NTP-G53 Set Up Timing" procedure on page
This task installs the LAN wires on the ONS 15454 ANSI backplane.
Wire wrapper
#22 or #24 AWG (0.51 mm² or 0.64 mm²) wire, preferably CAT-5 UTP
As needed
Onsite
None
Chapter 1 Install the Shelf and Common Control Cards
Output to external device 2
Output to external device 2
Chapter 20, "Security Reference."
Table 1-7 shows the LAN pin assignments.
To set up
6-4.
August 2005