Ntp- G12 Install And Close The Fmec Cover (Etsi Only) - Cisco ONS 15454 DWDM Installation And Operation Manual

Chapter 1 Install the Shelf and Common Control Cards
NTP-G12 Install and Close the FMEC Cover (ETSI Only)
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Insert the cover carefully onto the left pin of the hinge
Step 1
Step 2 Move the cover to the right side towards the right pin of the hinge.
Step 3 Pull the right side of the hinge-locking spring
spring snaps into place.
Figure 1-26
FMEC cover
Hinge-locking
Attach the ground wire to the shelf.
Step 4
Attach the washer and nut.
Step 5
Step 6 Attach the cover to the shelf using the screws on the top of the cover.
August 2005
This procedure installs and closes the ONS 15454 ETSI FMEC cover.
#2 Phillips screwdriver
Medium slot-head screwdriver
Small slot-head screwdriver
NTP-G4 Open and Remove the FMEC Cover (ETSI Only), page 1-23
Required
Onsite
None
ONS 15454 ETSI FMEC Cover
Pin hinge
spring
NTP-G12 Install and Close the FMEC Cover (ETSI Only)
(Figure
(Figure 1-26). Push the cover onto the right pin until the
F A N
F A IL
C R
IT
M A
J
M IN
Cisco ONS 15454 DWDM Installation and Operations Guide, R6.0
1-26).
1-63