Dlp- G183 Clear A Lock-On Or Lockout - Cisco ONS 15454 DWDM Installation And Operation Manual

DLP-G183 Clear a Lock-On or Lockout
In node view, click the Maintenance > Protection tabs.
Step 1
In the Protection Groups area, click the protection group that contains the card (Y-cable) or port (splitter)
Step 2
that you want to lock out.
In the Selected Group area, click the protect/standby card.
Step 3
In the Inhibit Switching drop-down list, click Lock Out.
Step 4
Click Yes in the confirmation dialog box.
Step 5
The lockout has been applied. Traffic cannot switch to the protect card. To clear the lockout, see the
"DLP-G183 Clear a Lock-On or Lockout" task on page
Note
Step 6 Return to your originating procedure (NTP).
DLP-G183 Clear a Lock-On or Lockout
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
In node view, click the Maintenance > Protection tabs.
Step 1
In the Protection Groups area, click the protection group that contains the card you want to clear.
Step 2
In the Selected Group area, click the card you want to clear.
Step 3
In the Inhibit Switching drop-down list, click Unlock.
Step 4
Click Yes in the confirmation dialog box.
Step 5
The lock-on or lockout is cleared.
Return to your originating procedure (NTP).
Step 6
Cisco ONS 15454 DWDM Installation and Operations Guide, R6.0
10-38
Provisioning a lockout raises a LOCKOUT-REQ or an FE-LOCKOUT condition in CTC.
Clearing the lockout switch request clears these conditions.
This task clears a lock-on or lockout.
None
DLP-G46 Log into CTC, page 2-25
DLP-G181 Apply a Lock-On, page 10-37
DLP-G182 Apply a Lockout, page 10-37
As needed
Both
Maintenance or higher
Chapter 10
10-38.
or
Manage the Node
September 2005