Dlp- G306 Provision The Txp_Mr_2.5G And Txpp_Mr_2.5G Cards Client Port Alarm And Tca Thresholds - Cisco ONS 15454 DWDM Installation And Operation Manual

DLP-G306 Provision the TXP_MR_2.5G and TXPP_MR_2.5G Cards Client Port Alarm and TCA Thresholds
Table 5-34
Signal
3R
2R
Under Types, click the Alarm radio button and click Refresh.
Step 8
Provision the trunk port (Port 2) Alarm thresholds for RX Power High to –7 dBm and the RX Power Low
Step 9
to –26 dBm.
Click Apply.
Step 10
Click the 1 Day PM interval radio button, click Refresh, then repeat Steps
Step 11
interval. If you have completed both intervals, continue with
Step 12 Return to your originating procedure (NTP).
DLP-G306 Provision the TXP_MR_2.5G and TXPP_MR_2.5G Cards Client Port
Alarm and TCA Thresholds
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
In node view, double-click the TXP_MR_2.5G or TXPP_MR_2.5G card where you want to change the
Step 1
client port alarm and TCA settings.
Click the Provisioning > Optics Thresholds tabs. The TCA thresholds are shown by default.
Step 2
Referring to
Step 3
Low, TX Power High, and TX Power Low based on the client interface at the other end. For additional
information about client SFP and XFP interfaces, also known as PPMs, refer to
Specifications."
Note
Note
Cisco ONS 15454 DWDM Installation and Operations Guide, R6.0
5-58
TXP_MR_2.5G and TXPP_MR_2.5G Trunk Port TCA Thresholds
TCA RX Power Low TCA RX Power High
–23 dBm –9 dBm
–24 dBm –9 dBm
This task provisions the client port alarm and TCA thresholds for the
TXP_MR_2.5G and TXPP_MR_2.5G cards.
None
DLP-G278 Provision the Optical Line Rate, page 5-6
DLP-G46 Log into CTC, page 2-25
Required
Onsite or remote
Provisioning or higher
Table 5-35, provision the Port 1 (client) TCA thresholds for RX Power High, RX Power
Do not modify the Laser Bias parameters.
You must modify 15 Min and 1 Day independently. To do so, choose the appropriate radio button
and click Refresh.
Chapter 5 Provision Transponder and Muxponder Cards
6 through
Step 12.
Appendix B, "Hardware
10 for the 1-day
September 2005