Ntp- G69 Enable, Modify, Or Disable Alarm Severity Filtering - Cisco ONS 15454 DWDM Installation And Operation Manual

Chapter 8 Manage Alarms
NTP-G69 Enable, Modify, or Disable Alarm Severity Filtering
Purpose
Tools/Equipment
Prerequisite Procedures None
Required/As Needed
Onsite/Remote
Security Level
Complete the
Step 1
severity filtering. If you are already logged in, continue with
As needed, complete the
Step 2
alarm filtering at the card, node, and network views for all nodes in the network. Alarm filtering can be
enabled for alarms, conditions, or events.
As needed, complete the
Step 3
on page 8-26
conditions.
As needed, complete the
Step 4
filtering for all network nodes.
Stop. You have completed this procedure.
DLP-G126 Enable Alarm Filtering
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
At node, network, or card view, click the Alarms tab.
Step 1
Click the Filter tool icon on the right side of the bottom toolbar.
Step 2
Note
Alarm filtering is enabled if the tool is selected and disabled if the tool is raised (not selected).
September 2005
Use this procedure to start, change, or stop alarm filtering for one or more
severities in the Alarms, Conditions, and History windows in all network
nodes.
None
As needed
Onsite or remote
Retrieve or higher
"DLP-G46 Log into CTC" task on page 2-25
"DLP-G126 Enable Alarm Filtering" task on page
"DLP-G127 Modify Alarm, Condition, and History Filtering Parameters" task
to modify the alarm filtering for network nodes to show or hide particular alarms or
"DLP-G128 Disable Alarm Filtering" task on page 8-28
This task enables alarm filtering for alarms, conditions, or event history in
all network nodes.
None
DLP-G46 Log into CTC, page 2-25
As needed
Onsite or remote
Retrieve or higher
The Filter tool icon differs from the Filter button at the bottom left of the screen.
NTP-G69 Enable, Modify, or Disable Alarm Severity Filtering
at the node where you want to enable alarm
Step
Cisco ONS 15454 DWDM Installation and Operations Guide, R6.0
2.
8-25. This task enables
to disable alarm profile
8-25