Dlp- G239 Change Section Trace Settings For Mxp_Mr_2.5G And Mxpp_Mr_2.5G Cards - Cisco ONS 15454 DWDM Installation And Operation Manual

Chapter 5 Provision Transponder and Muxponder Cards
Table 5-44 MXP_MR_2.5G and MXPP_MR_2.5G Muxponder Card Line SONET or SDH Tab Settings (continued)
Parameter Description
ALS Mode Sets the ALS function mode. The DWDM
transmitter supports ALS according to
ITU-T G.644 (06/99). ALS can be disabled or
can be set for one of three mode options.
ProvidesSync Sets the ProvidesSync card parameter. If
checked, the card is provisioned as an NE timing
reference.
SyncMsgIn Sets the EnableSync card parameter. Enables
synchronization status messages (S1 byte), which
allow the node to choose the best timing source.
Send Sets the Send DoNotUse card state. When
DoNotUse checked, sends a DUS message on the S1 byte.
1. SF BER and SD BER thresholds apply only to trunk ports (Port 9 for MXP_MR_2.5G and Ports 9 and 10 for MXPP_MR_2.5G).
Click Apply.
Step 4
Return to your originating procedure (NTP).
Step 5
DLP-G239 Change Section Trace Settings for MXP_MR_2.5G and
MXPP_MR_2.5G Cards
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
In node view, double-click the MXP_MR_2.5G or MXPP_MR_2.5G card where you want to change the
Step 1
section trace settings.
September 2005
DLP-G239 Change Section Trace Settings for MXP_MR_2.5G and MXPP_MR_2.5G Cards
Options
• Disable (default): ALS is off; the laser is not
automatically shut down when traffic outages (LOS)
occur.
Auto Restart: ALS is on; the laser automatically
•
shuts down when traffic outages (LOS) occur. It
automatically restarts when the conditions that
caused the outage are resolved.
Manual Restart: ALS is on; the laser automatically
•
shuts down when traffic outages (LOS) occur.
However, the laser must be manually restarted when
conditions that caused the outage are resolved.
Manual Restart for Test: Manually restarts the laser
•
for testing.
Checked or unchecked
Checked or unchecked
Checked or unchecked
This task changes the section trace settings for MXP_MR_2.5G and
MXPP_MR_2.5G muxponder cards.
None
DLP-G46 Log into CTC, page 2-25
As needed
Onsite or remote
Provisioning or higher
Cisco ONS 15454 DWDM Installation and Operations Guide, R6.0
5-73