Cisco ONS 15454 DWDM Installation And Operation Manual page 665

Chapter 13 Maintain the Node
Table 13-2 ONS 15454 Timing Report (continued)
Item Description
Status Date and time of
Changed the last status
At change.
Switch Type of switch.
Type
Reference Indicates the
timing reference.
Selected Indicates whether
the reference is
selected.
Facility Indicates the
timing facility
provisioned for
the reference on
the Provisioning >
Timing tab.
State Indicates the
timing reference
state.
Condition Indicates the
timing reference
state.
Condition Indicates the date
Changed and time of the
last status change
in MM/DD/YY
HH:MM:SS
format.
SSM Indicates whether
SSM is enabled
for the timing
reference.
September 2005
Option
—
AUTOMATIC
Manual
Force
Three timing references are
available on the Provisioning >
Timing tab.
Selected references are indicated
with an X.
BITS-1
BITS-2
OC-N/STM-N card with port
number
Internal clock
IS
OOS
OKAY
OOB
—
Enabled
Disabled
NTP-G113 View the ONS 15454 Timing Report
Option Description
—
The timing switch was system-generated.
The timing switch was a user-initiated Manual switch.
The timing switch was user-initiated Force switch.
—
—
The timing facility is a building integrated timing supply
(BITS) clock attached to the node's BITS-1 pins.
The timing facility is a BITS clock attached to the node's
BITS-2 pins.
If the node is set to line timing, this is the OC-N/STM-N
card and port provisioned as the timing reference.
The node is using its internal clock.
The timing reference is in service.
The timing reference is out of service.
The reference is valid to use as a timing reference.
Out of bounds; the reference is not valid and cannot be
used as a timing reference, for example, a BITS clock is
disconnected.
—
SSM is enabled.
SSM is not enabled.
Cisco ONS 15454 DWDM Installation and Operations Guide, R6.0
13-21