Dlp- G160 Change The Node Name, Date, Time, And Contact Information - Cisco ONS 15454 DWDM Installation And Operation Manual

Chapter 10 Manage the Node
DLP-G160 Change the Node Name, Date, Time, and Contact Information
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Changing the date, time, or time zone might invalidate the node's performance monitoring counters.
Caution
In node view, click the Provisioning > General tabs.
Step 1
Change any of the following:
Step 2
•
•
•
•
•
•
•
•
•
•
•
•
See the
detailed field descriptions.
Click Apply.
Step 3
Step 4 Return to your originating procedure (NTP).
September 2005
This task changes basic information such as node name, date, time, and
contact information.
None
DLP-G46 Log into CTC, page 2-25
As needed
Onsite or remote
Provisioning or higher
General: Node Name
General: Contact
Location: Latitude
Location: Longitude
Location: Description
To see changes to longitude or latitude on the network map, you must go to network view
Note
and right-click the specified node, then click Reset Node Position.
Time: Use NTP/SNTP Server
Time: Date (M/D/Y)
Time: Time (H:M:S)
Time: Time Zone
Time: Use Daylight Saving Time
AIS-V Insertion On STS-1 Signal Degrade - Path: Insert AIS-V on STS-1 SD-P
AIS-V Insertion On STS-1 Signal Degrade - Path: SD-P BER
"NTP-G24 Set Up Name, Date, Time, and Contact Information" procedure on page 3-8
DLP-G160 Change the Node Name, Date, Time, and Contact Information
Cisco ONS 15454 DWDM Installation and Operations Guide, R6.0
for
10-7