Cisco ONS 15454 DWDM Installation And Operation Manual page 635

Add and Remove Cards and Nodes
This chapter provides procedures for adding and removing dense wavelength division multiplexing
(DWDM) cards and nodes.
Unless otherwise specified, "ONS 15454" refers to both ANSI and ETSI shelf assemblies.
Note
Before You Begin
Before performing any of the following procedures, investigate all alarms and clear any trouble
conditions. Refer to the Cisco ONS 15454 SONET and DWDM Troubleshooting Guide or the
Cisco ONS 15454 SDH Troubleshooting Guide as necessary for general troubleshooting information
and alarm or error descriptions.
This section lists the chapter procedures (NTPs). Turn to a procedure to view its tasks (DLPs).
1.
2.
3.
4.
NTP-G107 Remove and Replace DWDM Cards
Purpose
Tools/Equipment
Prerequisite Procedures A card installation procedure
Required/As Needed
Onsite/Remote
Security Level
Caution Removing and replacing cards can be traffic affecting.
September 2005
NTP-G107 Remove and Replace DWDM Cards, page
NTP-G127 Add an AD-xC-xx.x Card to an OADM Node, page
NTP-G129 Add a DWDM Node, page
NTP-G130 Remove a DWDM Node, page
This procedure removes and replaces DWDM cards installed in the
ONS 15454 shelf and rack.
None
As needed
Onsite
Provisioning or higher
C H A P T E R
12-1—Complete as needed.
12-7—Complete as needed.
12-9—Complete as needed.
Cisco ONS 15454 DWDM Installation and Operations Guide, R6.0
12
12-5—Complete as needed.
12-1