Channel Plan - Cisco ONS 15454 DWDM Installation And Operation Manual

Chapter 16 Card Reference
Figure 16-25
30.3 to 36.6
8 CHS RX
38.1 to 44.5
8 CHS RX
46.1 to 52.5
8 CHS RX
54.1 to 60.6
8 CHS RX
The 32MUX-O has four receive connectors that accept multifiber push-on (MPO) cables, which break
out into eight separate cables, on its front panel for the client input interfaces. The 32MUX-O also has
two LC-PC-II optical connectors, one for the main output and the other for the monitor port.
Figure 16-26
Figure 16-26
P

16.6.1.1 Channel Plan

The 32MUX-O is typically used in hub nodes and provides the multiplexing of 32 channels, spaced at
100 GHz, into one fiber before their amplification and transmission along the line. The channel plan is
shown in
April 2006
32MUX-O Block Diagram
FPGA
For SCL Bus
management
SCL Bus SCL Bus
TCCi M TCCi P
shows the 32MUX-O optical module functional block diagram.
32MUX-O Optical Module Functional Block Diagram
1
Inputs
32
Physical photodiode
Variable optical attenuator
Table 16-26.
Optical
module
Processor DC/DC
P1
P2
P3
P4
P29
P30
P31
P32
Control
Cisco ONS 15454 DWDM Installation and Operations Guide, R6.0
16.6.1 32MUX-O Card
MON
COM TX
Power supply
Input filters
BAT A&B
MON
COM TX
Control
interface
16-47