Ntp- G133 View And Manage Osi Information - Cisco ONS 15454 DWDM Installation And Operation Manual

Chapter 13 Maintain the Node
NTP-G133 View and Manage OSI Information
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Note Additional information about the ONS 15454 implementation of OSI is provided in the
Connectivity Reference
Complete the
Step 1
Step 2.
Perform any of the following tasks as needed:
Step 2
•
•
•
Stop. You have completed this procedure.
DLP-G298 View IS-IS Routing Information Base
Purpose
Tools/Equipment
Prerequisite procedures
Required/As needed
Onsite/Remote
Security Level
In node view, click the Maintenance > OSI > IS-IS RIB tabs.
Step 1
September 2005
This procedure allows you to view and manage Open Systems
Interconnection (OSI) including the End System to Intermediate System
(ES-IS) and Intermediate System to Intermediate System (IS-IS) routing
information tables, the Target Identifier Address Resolution Protocol
(TARP) data cache, and the manual area table.
None
NTP-G103 Back Up the Database, page 13-2
NTP-G17 Set Up Computer for CTC, page 2-2
NTP-G132 Provision OSI, page 3-25
As needed
Onsite or remote
Provisioning or higher
chapter.
"DLP-G46 Log into CTC" task on page
DLP-G298 View IS-IS Routing Information Base, page 13-9
DLP-G299 View ES-IS Routing Information Base, page 13-10
DLP-G300 Manage the TARP Data Cache, page 13-11
This task allows you to view the IS-IS protocol routing information base
(RIB). IS-IS is an OSI routing protocol that floods the network with
information about NEs on the network. Each NE uses the information to
build a complete and consistent picture of a network topology. The IS-IS
RIB shows the network view from the perspective of the IS node.
None
DLP-G46 Log into CTC, page 2-25
As needed
Onsite or remote
Provisioning or higher
NTP-G133 View and Manage OSI Information
2-25. If you are already logged in, continue with
Cisco ONS 15454 DWDM Installation and Operations Guide, R6.0
Management
13-9