Faceplates - Cisco ONS 15454 DWDM Installation And Operation Manual

Chapter 16 Card Reference
16.8.6 MXP_MR_2.5G and MXPP_MR_2.5G Cards
The MXP_MR_2.5G card features a 1550-nm laser for the trunk/line port and a 1310-nm or 850-nm laser
(depending on the SFP) for the client ports. The card contains eight 12.5 degree downward tilt SFP
modules for the client interfaces. For optical termination, each SFP uses two LC connectors, which are
labeled TX and RX on the faceplate. The trunk port is a dual-LC connector with a 45 degree downward
angle.
The MXPP_MR_2.5G card features a 1550-nm laser for the trunk/line port and a 1310-nm or 850-nm
laser (depending on the SFP) for the client port. The card contains eight 12.5 degree downward tilt SFP
modules for the client interfaces. For optical termination, each SFP uses two LC connectors, which are
labeled TX and RX on the faceplate. There are two trunk port connectors (one for working and one for
protect). Each is a dual-LC connector with a 45-degree downward angle.

16.8.6.1 Faceplates

Figure 16-66 shows the MXP_MR_2.5G and MXPP_MR_2.5G faceplates.
Cisco ONS 15454 DWDM Installation and Operations Guide, R6.0
16-109
April 2006