Table 11-17 Multiplexer And Demultiplexer Card Optical Channel Settings; Dlp- G210 Change Optical Channel Settings For Multiplexer And Demultiplexer Cards - Cisco ONS 15454 DWDM Installation And Operation Manual

DLP-G210 Change Optical Channel Settings for Multiplexer and Demultiplexer Cards
Table 11-17 Multiplexer and Demultiplexer Card Optical Channel Settings
Parameter Description
Port # (Display only) Displays the port number.
Port Name Provides the ability to assign the specified port a
name.
Admin State Sets the port service state unless network
conditions prevent the change. For more
information about administrative states, see
Appendix C, "DWDM Administrative and Service
States."
Line Direction Provides the ability to associate a card with the line
direction. CTC automatically configures the line
direction during node setup. To change this setting,
you must change the Cisco MetroPlanner site plan
and import it to the node.
Service State (Display only) Identifies the autonomously
generated state that gives the overall condition of
the port. Service states appear in the format:
Primary State-Primary State Qualifier, Secondary
State. For more information about service states,
see Appendix C, "DWDM Administrative and
Service States."
Type (Display only) Identifies the type of port.
Power (Display only) Shows the current power level per
port.
VOA Mode (Display only; 32MUX-O, 32DMX-0, 4MD only)
Shows the current functional mode of the VOA.
VOA Power (Display only; 32MUX-O, 32DMX-0, 4MD only)
Ref. Shows the Power setpoint that must be reached on
the path where a VOA is present when the VOA
Mode is Constant Power.
Demultiplexers show the reference value of the
desired optical power going to the client.
Multiplexers show the reference value of the
desired per-channel optical power. This parameter
can only be modified by ANS.
Cisco ONS 15454 DWDM Installation and Operations Guide, R6.0
11-28
Chapter 11
Options
Displays port number and TX or RX.
User-defined. Name can be up to 32 alphanumeric/
special characters. Blank by default. Double-click,
enter the name, and press Enter.
See the "DLP-G104 Assign a Name to a Port" task on
page 7-10.
From the drop-down list, choose one of the following:
• IS/Unlocked
IS,AINS/Unlocked,automaticInService
•
OOS,DSBLD/Locked,disabled
•
OOS,MT/Locked,maintenance
•
From the drop-down list, choose one of the following:
East to West
•
West to East
•
IS-NR/Unlocked-enabled
•
• OOS-AU,AINS/Unlocked-disabled,
automaticInService
OOS-MA,DSBLD/Locked-enabled,disabled
•
OOS-MA,MT/Locked-enabled,maintenance
•
ADD
•
DROP
•
—
Constant Power
•
Constant Attenuation
•
—
Change DWDM Card Settings
September 2005