Ntp- G106 Reset Cards Using Ctc - Cisco ONS 15454 DWDM Installation And Operation Manual

NTP-G106 Reset Cards Using CTC
NTP-G106 Reset Cards Using CTC
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Complete the
Step 1
TCC2/TCC2P reset. If you are already logged in, continue with
As needed, complete the
Step 2
As needed, complete the
Step 3
Stop. You have completed this procedure.
DLP-G250 Reset the TCC2/TCC2P Card
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Do not reach into a vacant slot or chassis while you install or remove a module or a fan. Exposed
Warning
circuitry could constitute an energy hazard. Statement 206
Before you reset the TCC2/TCC2P, you should wait at least 60 seconds after the last provisioning
Note
change you made to avoid losing any changes to the database.
When a software reset is performed on an active TCC2/TCC2P, the AIC-I card goes through an
Note
initialization process and also resets. The AIC-I card reset is normal and happens each time an active
TCC2/TCC2P card goes through a software-initiated reset.
Cisco ONS 15454 DWDM Installation and Operations Guide, R6.0
13-12
This procedure resets the TCC2/TCC2P and DWDM cards using CTC.
None
DLP-G33 Install the TCC2 or TCC2P Card, page 1-72
As needed
Onsite or remote
Superuser
"DLP-G46 Log into CTC" task on page 2-25
"DLP-G250 Reset the TCC2/TCC2P Card" task on page
"DLP-G251 Reset DWDM Cards Using CTC" task on page
This task resets the TCC2/TCC2P card and switches the node to the
redundant TCC2/TCC2P.
None
DLP-G33 Install the TCC2 or TCC2P Card, page 1-72
DLP-G46 Log into CTC, page 2-25
As needed
Onsite or remote
Superuser
Chapter 13
at the node where you are performing the
Step 2.
13-12.
Maintain the Node
13-13.
September 2005