Dlp- G224 Change Section Trace Settings For Mxp_2.5G_10G And Mxp_2.5G_10E Cards - Cisco ONS 15454 DWDM Installation And Operation Manual

DLP-G224 Change Section Trace Settings for MXP_2.5G_10G and MXP_2.5G_10E Cards
Table 5-17 MXP_2.5G_10G or MXP_2.5G_10E Muxponder Card Line Settings (continued)
Parameter Description
SyncMsgIn Enables synchronization status messages (S1 byte),
which allow the node to choose the best timing
source. (This parameter does not appear for the
MXP_2.5G_10E trunk port.)
Send When checked, sends a DUS message on the S1
DoNotUse byte. (This parameter does not appear for the
MXP_2.5G_10E trunk port.)
Reach Displays the optical reach distance of the client
port.
Wavelength Displays the wavelength of the client port.
Click Apply.
Step 4
Return to your originating procedure (NTP).
Step 5
DLP-G224 Change Section Trace Settings for MXP_2.5G_10G and
MXP_2.5G_10E Cards
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Note
Step 6 In node view, double-click the MXP_2.5G_10G or MXP_2.5G_10E card where you want to change the
section trace settings.
Cisco ONS 15454 DWDM Installation and Operations Guide, R6.0
5-36
This task changes the section trace settings for MXP_2.5G_10G and
MXP_2.5G_10E muxponder cards.
None
DLP-G46 Log into CTC, page 2-25
As needed
Onsite or remote
Provisioning or higher
The Section Trace tab appears only if you have created a PPM for the card.
Chapter 5 Provision Transponder and Muxponder Cards
Options
Checked or unchecked
Checked or unchecked
• Autoprovision (default)
• I1
S1
•
S2
•
L1
•
L2
•
L3
•
First Tunable Wavelength
•
• Further wavelengths: 1310 nm to 1550 nm
100-GHz ITU spacing, CWDM spacing
Supported wavelengths are marked by asterisks
•
(**)
September 2005