Ntp- G135 Edit Network Element Defaults - Cisco ONS 15454 DWDM Installation And Operation Manual

NTP-G135 Edit Network Element Defaults
NTP-G135 Edit Network Element Defaults
Purpose
Tools/Equipment
Prerequisite Procedures None
Required/As Needed
Onsite/Remote
Security Level
For a list of NE defaults, see
Note
Complete the
Step 1
defaults.
Click the Provisioning > Defaults tabs.
Step 2
Under Defaults Selector, choose either a card (if editing card-level defaults) or NODE (if editing
Step 3
node-level defaults). Clicking on the node name (at the top of the Defaults Selector column) lists all
available NE defaults (both node- and card-level) under Default Name.
Locate a default that you want to change under Default Name.
Step 4
Step 5 Click in the Default Value column for the default property that you are changing and either choose a
value from the drop-down list (when available), or type in the desired new value.
Note
Click Apply (click in the Default Name column to activate the Apply button if it is unavailable). You
Step 6
can modify multiple default values before applying the changes.
A pencil icon will appear next to any default value that will be changed as a result of editing the defaults
file.
Step 7 If you are modifying node-level defaults, a dialog box appears telling you that defaults were successfully
applied to the node. Click Yes.
If you are modifying the IIOP Listener Port setting, a dialog box appears warning you that the node will
reboot and asks if you want to continue. Click Yes.
Note
Cisco ONS 15454 DWDM Installation and Operations Guide, R6.0
13-42
This procedure edits the factory-configured NE defaults using the NE
Defaults editor. The new defaults can be applied to the node where they are
edited, or exported to a file to be imported for use on other nodes.
None
As needed
Onsite or remote
Superuser
Appendix D, "Network Element Defaults."
"DLP-G46 Log into CTC" task on page 2-25
If you click Reset before you click Apply, all values will return to their original settings.
Changes to most node defaults reprovision the node when you click Apply. Changes made to
card settings using the Defaults Editor do not change the settings for cards that are already
installed or slots that are preprovisioned for cards, but rather, change only cards that are installed
or preprovisioned thereafter. To change settings for installed cards or preprovisioned slots, see
Chapter 11, "Change DWDM Card Settings."
cards see Chapter 5, "Provision Transponder and Muxponder Cards."
Chapter 13
at the node where you want to edit NE
To change settings for transponder or muxponder
Maintain the Node
September 2005