Cisco ONS 15454 DWDM Installation And Operation Manual page 252

DLP-G69 Install Fiber-Optic Cables for an OSC Regeneration Node
1 West OSC-CSM LINE RX to east OSC-CSM
or OPT-BST LINE TX on adjacent node
2
West OSC-CSM LINE TX to east OSC-CSM
or OPT-BST LINE RX on adjacent node
3 West OSC-CSM COM TX to east OSC-CSM
COM RX
Plug one end of the fiber cable into the desired RX port.
Step 2
Route the fiber cable on the card faceplate through the fiber clip on the faceplate, if provided. (Fiber clips
Step 3
are factory-attached to the faceplates of OSCM, OPT-PRE, and OPT-BST cards.)
Step 4 Route the fiber cable through the cable-routing channel and cutout on the appropriate side of the shelf
assembly, as necessary
As needed, route slack fiber-optic cable around the round cable retainers in the fiber-storage tray
Step 5
(Figure 15-38 on page
When you close the fiber-storage tray, the cables must not be pinched, and the cable bend radius must
Caution
be equal to or greater than the minimum radius that is recommended in your site specifications. As you
route each cable through the fiber-storage tray, make sure that adequate cable slack remains.
Step 6 Route the fiber cable out either side of the fiber-storage tray as necessary.
Plug the other end of the cable into the desired TX port.
Step 7
Note
Step 8 Repeat
Step 9 Return to your originating procedure (NTP).
Cisco ONS 15454 DWDM Installation and Operations Guide, R6.0
3-62
4
5
6
(Figure 15-35 on page
15-40).
Cards display an SF LED after the OSC terminations are created (see the
OSC Terminations" procedure on page
correctly. For example, an RX port is connected to another RX port or a TX port is connected to
another TX port.
2 through 7 until you have connected the nodes according to the site plan.
West OSC-CSM COM RX to east OSC-CSM COM TX
East OSC-CSM LINE RX to west OSC-CSM or
OPT-BST LINE TX on adjacent node
East OSC-CSM LINE TX to west OSC-CSM or
OPT-BST LINE RX on adjacent node
15-37).
3-84) if transmit and receive fibers are not connected
Chapter 3 Turn Up a Node
"NTP-G38 Provision
September 2005