Ntp- G127 Add An Ad-Xc-Xx.x Card To An Oadm Node - Cisco ONS 15454 DWDM Installation And Operation Manual

NTP-G127 Add an AD-xC-xx.x Card to an OADM Node
Step 9 In the Select Node dialog box, choose the OADM node where you will add the AD-xCxx.x card and click
OK.
In the TL1 dialog box, use the DLT-WLEN command to delete the OCHNC cross-connects for the
Step 10
express path OCHNCs listed in
DLT-WLEN:[<TID>]:<AID>:<CTAG>[:::CMDMDE=<CMDMDE>];
where:
<AID> is the wavelength AID per ring direction from the wavelength (WLEN) section.
•
• <CMDMDE> indicates the command execution mode.
For additional information, including valid command values, refer to the Cisco ONS SONET TL1
Command Guide or the Cisco ONS 15454 SDH TL1 Command Guide.
Close the TL1 session.
Step 11
Step 12 In node view, click the Provisioning > WDM-ANS > Connections tabs.
Step 13 Highlight the two express connections that carry the circuits passing through the node. (The express
connections are the only ones connecting an EXP_TX port on the last west-side OADM card, W > E,
with an EXP_RX port on the first east-side OADM card, W > E.)
Click Delete.
Step 14
Remove the physical express cables between the EXP_TX and EXP_RX ports specified in
Step 15
Insert the new AD-xCxx.x card in the slot identified by your Cisco MetroPlanner site plan.
Step 16
Complete the
Step 17
page 3-48
MetroPlanner.
Complete the
Step 18
Import the recalculated OADM site parameters. See the
Step 19
Configuration File" task on page
Step 20 In node view, click the Provisioning > WDM-ANS > Port Status tabs.
Click Launch ANS.
Step 21
From the Tools menu, choose Open TL1 Session.
Step 22
In the Select Node dialog box, choose the OADM node and click OK.
Step 23
In the TL1 dialog box, use the ENT-WLEN command to create the OCHNC cross-connects that were
Step 24
deleted in
ENT-WLEN:[<TID>]:<AID>:<CTAG>:::[SIZE=<SIZE>]:[<PST>],[<SST>];
where:
<AID> is the wavelength AID.
•
<SIZE> is the circuit size allocated on this wavelength.
•
<PST> is the primary state.
•
• <SST> is the secondary state.
For additional information and a list of valid command values, see the Cisco ONS SONET TL1 Command
Guide or the Cisco ONS 15454 SDH TL1 Command Guide.
Close the TL1 dialog box.
Step 25
Step 26 In node view, click the Circuits tab.
Cisco ONS 15454 DWDM Installation and Operations Guide, R6.0
12-6
Step
"NTP-G34 Install Fiber-Optic Cables on DWDM Cards and DCUs" procedure on
for the OADM node, following the new internal connections table generated by Cisco
"NTP-G36 Calculate Cable Connections" procedure on page
3-82.
Step 10, as follows:
4, as follows:
"NTP-G138 Import a Cisco MetroPlanner
Chapter 12 Add and Remove Cards and Nodes
3-80.
September 2005
Step 13.