Ntp- G88 Modify Users And Change Security - Cisco ONS 15454 DWDM Installation And Operation Manual

Chapter 10 Manage the Node
Step 6 In the BITS In section, you can change the following information:
Note
•
•
•
•
•
•
In the BITS In section, you can change the following information:
Step 7
•
•
•
•
•
Click Apply. Confirm that the changes appear.
Step 8
Internal timing is Stratum 3 and is not intended for permanent use. All ONS 15454s should be timed to
Caution
a Stratum 2 or better primary reference source.
Complete the
Step 9
Stop. You have completed this procedure.
NTP-G88 Modify Users and Change Security
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Complete the
Step 1
Step 2.
Complete the
Step 2
September 2005
The BITS Facilities section sets the parameters for your BITS1 and BITS2 timing references.
Many of these settings are determined by the timing source manufacturer. If equipment is timed
through BITS Out, you can set timing parameters to meet the requirements of the equipment.
BITS In State
Coding
State
Framing
Sync Messaging
Admin SSM
BITS Out State
Coding
Framing
AIS Threshold
LBO
"NTP-G103 Back Up the Database" procedure on page
This procedure modifies user and security properties for the ONS 15454.
None
NTP-G23 Create Users and Assign Security, page 3-5
As needed
Onsite or remote
Superuser
"DLP-G46 Log into CTC" task on page
"NTP-G103 Back Up the Database" procedure on page
NTP-G88 Modify Users and Change Security
2-25. If you are already logged in, continue with
Cisco ONS 15454 DWDM Installation and Operations Guide, R6.0
13-2.
13-2.
10-45