Figure 1-27 Backplane Attachment For The Rear Cover; Ntp- G13 Install The Rear Cover (Ansi Only) - Cisco ONS 15454 DWDM Installation And Operation Manual

NTP-G13 Install the Rear Cover (ANSI Only)
Step 7 Continue with the
Stop. You have completed this procedure.
NTP-G13 Install the Rear Cover (ANSI Only)
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Locate the three screws that run vertically along on each side of the backplane
Step 1
Figure 1-27
Tip
Cisco ONS 15454 DWDM Installation and Operations Guide, R6.0
1-64
"NTP-G14 Install DWDM Equipment" procedure on page
The following procedure explains how to install the rear cover on an
ONS 15454 ANSI shelf.
#2 Phillips screwdriver
Medium slot-head screwdriver
Small slot-head screwdriver
NTP-G5 Remove the Backplane Covers (ANSI Only), page 1-26
Required
Onsite
None
Backplane Attachment for the Rear Cover
Screw locations
for attaching the
rear cover
Only six screws (three on each side) line up with the screw slots on the mounting brackets,
making the screws easy to locate.
Chapter 1 Install the Shelf and Common Control Cards
1-66.
(Figure 1-27).
August 2005