Ntp- G18 Set Up Ctc Computer For Local Craft Connection To The Ons 15454 - Cisco ONS 15454 DWDM Installation And Operation Manual

Chapter 2 Connect the PC and Log into the GUI
NTP-G18 Set Up CTC Computer for Local Craft Connection to the
ONS 15454
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Complete one of the CTC computer setup tasks shown in
Step 1
environment.
Table 2-1
CTC Connection Environment
•
•
•
•
•
•
•
•
Note
September 2005
This procedure explains how to set up a PC running Windows or a Solaris
workstation for an onsite local craft connection to the ONS 15454.
Network interface card (NIC), also referred to as an Ethernet card
Straight-through (CAT-5) LAN cable
NTP-G17 Set Up Computer for CTC, page 2-2
As needed
Onsite or remote
None
CTC Computer Setup for Local Craft Connections to the ONS 15454
You are connecting from a Windows PC.
All nodes that you will access run software earlier
than Release 3.3.
You will connect to one ONS 15454.
You need to access non-ONS 15454 applications
such as ping and tracert (trace route).
You are connecting from a Windows PC.
The CTC computer is provisioned for Dynamic
Host Configuration Protocol (DHCP).
The ONS 15454 has DHCP forwarding enabled.
The ONS 15454 is connected to a DHCP server.
The ONS 15454 does not provide IP addresses.
If DHCP is enabled, it passes DCHP requests to
an external DHCP server.
NTP-G18 Set Up CTC Computer for Local Craft Connection to the ONS 15454
Table 2-1
CTC Computer Setup Task
DLP-G39 Set Up a Windows PC for Craft
Connection to an ONS 15454 on the Same
Subnet Using Static IP Addresses, page 2-11
DLP-G40 Set Up a Windows PC for Craft
Connection to an ONS 15454 Using Dynamic
Host Configuration Protocol, page 2-13
Do not use this task for initial node
Note
turn-up. Use the task only if DHCP
forwarding is enabled on the
ONS 15454. By default, DHCP is not
enabled. To enable it, see the
"NTP-G26 Set Up CTC Network
Access" procedure on page
Cisco ONS 15454 DWDM Installation and Operations Guide, R6.0
based on your CTC connection
3-11.
2-9