Dlp- G137 Set Auto-Refresh Interval For Displayed Pm Counts - Cisco ONS 15454 DWDM Installation And Operation Manual

DLP-G137 Set Auto-Refresh Interval for Displayed PM Counts
Step 9 Return to your originating procedure (NTP).
DLP-G137 Set Auto-Refresh Interval for Displayed PM Counts
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
In node view (single-shelf mode), or shelf view (multishelf mode), double-click the DWDM, TXP, or
Step 1
MXP card where you want to set the auto-refresh interval for displayed PM counts. The card view
appears.
Click the Performance tab.
Step 2
If you want to set the PM auto-refresh interval for a subtab, click the relevant subtab(s), located along
Step 3
the left side of the Performance tab.
Note
Step 4 If you want to set the PM auto-refresh interval for a specific port, select the port from the Ports
drop-down list (where available).
From the Auto-refresh drop-down list, choose one of the following options:
Step 5
•
•
•
•
•
•
Click Refresh. The PM counts for the newly selected auto-refresh time interval appear.
Step 6
Depending on the selected auto-refresh interval, the displayed PM counts automatically update when
each refresh interval completes. If the auto-refresh interval is set to None, the PM counts that appear are
not updated unless you click Refresh.
Step 7 Return to your originating procedure (NTP).
Cisco ONS 15454 DWDM Installation and Operations Guide, R6.0
9-8
Performance subtabs vary, depending on the card viewed.
None: This option disables the auto-refresh feature.
15 Seconds: This option sets the window auto-refresh at 15-second time intervals.
30 Seconds: This option sets the window auto-refresh at 30-second time intervals.
1 Minute: This option sets the window auto-refresh at 1-minute time intervals.
3 Minutes: This option sets the window auto-refresh at 3-minute time intervals.
5 Minutes: This option sets the window auto-refresh at 5-minute time intervals.
This task changes the window auto-refresh intervals for updating the PM
counts.
None
DLP-G46 Log into CTC, page 2-25
As needed
Onsite or remote
Retrieve or higher
Chapter 9 Monitor Performance
September 2005