Ntp- G26 Set Up Ctc Network Access - Cisco ONS 15454 DWDM Installation And Operation Manual

Chapter 3 Turn Up a Node
NTP-G26 Set Up CTC Network Access
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Step 1 Complete the
Step
Complete the
Step 2
address, subnet mask, default router, DHCP server, IIOP listener port, and SOCKS proxy server settings.
Tip
Step 3 If TCC2P cards are installed and you want to turn on the ONS 15454 secure mode, which allows two IP
addresses to be provisioned for the node, complete the
on page
Note
If static routes are needed, complete the
Step 4
information about static routes, see
Step 5 If the ONS 15454 is connected to a LAN or WAN that uses OSPF and you want to share routing
information between the LAN/WAN and the ONS network, complete the
Open Shortest Path First Protocol" task on page
If the ONS 15454 is connected to a LAN or WAN that uses RIP, complete the
Step 6
Change Routing Information Protocol" task on page
Stop. You have completed this procedure.
September 2005
This procedure provisions network access for a node, including its subnet
mask, default router, Dynamic Host Configuration Protocol (DHCP)
server, Internet Inter-Orb Protocol (IIOP) listener port, gateway settings,
static routes, Open Shortest Path First (OSPF) protocol, and Routing
Information Protocol (RIP).
None
NTP-G22 Verify Common Card Installation, page 3-4
Required
Onsite or remote
Superuser
"DLP-G46 Log into CTC" task on page
2.
"DLP-G56 Provision IP Settings" task on page 3-12
If you cannot log into the node, you can change its IP address, default router, and network mask
by using the LCD on the ONS 15454 fan-tray assembly (unless LCD provisioning is
suppressed). See the "DLP-G57 Set the IP Address, Default Router, and Network Mask Using
the LCD" task on page 3-15
other network settings.
3-17.
Secure mode is not available if TCC2 cards are installed.
2-25. If you are already logged in, continue with
for instructions. However, you cannot use the LCD to provision any
"DLP-G264 Enable Node Security Mode" task
"DLP-G58 Create a Static Route" task on page
Chapter 22, "Management Connectivity Reference."
3-19.
3-22.
Cisco ONS 15454 DWDM Installation and Operations Guide, R6.0
NTP-G26 Set Up CTC Network Access
to provision the ONS 15454 IP
3-18. For more
"DLP-G59 Set Up or Change
"DLP-G60 Set Up or
3-11