Test Equipment (Etsi) - Cisco ONS 15454 DWDM Installation And Operation Manual

NTP-G1 Unpack and Inspect the Shelf Assembly

Test Equipment (ETSI)

To install the ONS 15454 ETSI, you need the following test equipment.
•
•
•
NTP-G1 Unpack and Inspect the Shelf Assembly
Purpose
Tools/Equipment
Prerequisite Procedures None
Required/As Needed
Onsite/Remote
Security Level
Step 1 Complete the
Complete the
Step 2
Continue with the
Step 3
Stop. You have completed this procedure.
DLP-G1 Unpack and Verify the Shelf Assembly
Purpose
Tools/Equipment
Prerequisite Procedures None
Required/As Needed
Onsite/Remote
Security Level
When you receive the ONS 15454 system equipment at the installation site, open the top of the box. The
Step 1
Cisco Systems logo designates the top of the box.
Remove the foam inserts from the box. The box contains the ONS 15454 shelf (wrapped in plastic) and
Step 2
a smaller box of items needed for installation.
Step 3 To remove the shelf, grasp both rings of the shelf removal strap and slowly lift the shelf out of the box.
Open the smaller box of installation materials, and verify that you have all items listed in the
Step 4
Tools and Equipment (ETSI)" section on page 1-4
section on page
Cisco ONS 15454 DWDM Installation and Operations Guide, R6.0
1-6
Voltmeter
Power meter (only for use with fiber optics)
Bit error rate (BER) tester for E1-N-14, E1-42, E3-12, DS3i-N-12, STM1E-12, and FMEC cards
This procedure explains how to unpack the ONS 15454 shelf assemblies
and verify their contents.
Pinned hex (Allen) key for front door
Required
Onsite
None
"DLP-G1 Unpack and Verify the Shelf Assembly" task on page
"DLP-G2 Inspect the Shelf Assembly" task on page
"NTP-G1 Unpack and Inspect the Shelf Assembly" procedure on page
This task removes the shelf assembly from the package.
None
Required
Onsite
None
1-3.
Chapter 1 Install the Shelf and Common Control Cards
1-7.
or the "Required Tools and Equipment (ANSI)"
1-6.
1-6.
"Required
August 2005