Dlp- G112 Delete Overhead Circuits - Cisco ONS 15454 DWDM Installation And Operation Manual

DLP-G112 Delete Overhead Circuits
•
Click Next.
Step 6
Click Finish.
Step 7
Return to your originating procedure (NTP).
Step 8
DLP-G112 Delete Overhead Circuits
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Caution Deleting overhead circuits is service affecting if the circuits are in service (IS). To put circuits out of
service (OOS), see the
Step 1 From the View menu, choose Go to Network View.
Step 2 Click the Provisioning > Overhead Circuits tabs.
Click the overhead circuit that you want to delete: local or express orderwire, user data, IP-encapsulated
Step 3
tunnel, or DCC tunnel.
Step 4 Click Delete.
Step 5 In the confirmation dialog box, click Yes to continue.
Return to your originating procedure (NTP).
Step 6
Cisco ONS 15454 DWDM Installation and Operations Guide, R6.0
7-22
Old IP Address—Type the node's original IP address.
This task deletes overhead circuits. Overhead circuits include
IP-encapsulated tunnels, AIC and AIC-I card orderwire, and UDCs.
None
DLP-G46 Log into CTC, page 2-25
As needed
Onsite or remote
Provisioning or higher
"DLP-G108 Change the Service State for a Port" task on page
Chapter 7 Create Channels and Circuits
7-18.
September 2005