Before You Begin - Cisco ONS 15454 DWDM Installation And Operation Manual

Manage the Node
This chapter explains how to modify node provisioning for the Cisco ONS 15454 and perform common
management tasks such as monitoring the dense wavelength division multiplexing (DWDM) automatic
power control (APC) and span loss values. To provision a new node, see
To change default network element (NE) settings and to view a list of those settings, refer to
Appendix B, "Hardware Specifications."
Unless otherwise specified, "ONS 15454" refers to both ANSI and ETSI shelf assemblies.
Note

Before You Begin

Before performing the following procedures, investigate all alarms and clear any trouble conditions.
Refer to the Cisco ONS 15454 Troubleshooting Guide or the Cisco ONS 15454 SDH Troubleshooting
Guide as necessary.
This section lists the chapter procedures (NTPs). Turn to a procedure for applicable tasks (DLPs).
1.
2.
3.
4.
5.
6.
7.
September 2005
NTP-G76 Verify Optical Span Loss Using CTC, page
view or modify the DWDM span loss values.
NTP-G77 Manage Automatic Power Control, page
manage the DWDM APC.
NTP-G78 View ROADM Node Power Equalization, page
to view and update a reconfigurable optical add/drop multiplexing (ROADM) node's power
equalization.
NTP-G80 Change Node Management Information, page
to change node name, contact information, latitude, longitude, date, time, and login legal disclaimer.
NTP-G134 Modify OSI Provisioning, page
Open System Interconnection (OSI) parameters including the OSI routing mode, Target Identifier
Address Resolution Protocol (TARP), routers, subnets, and IP-over-CLNS tunnels.
NTP-G81 Change CTC Network Access, page
the IP address, default router, subnet mask, network configuration settings, and static routes.
NTP-G82 Customize the CTC Network View, page
create domains and customize the appearance of the network map, including specifying a different
default map, creating domains, selecting your own map or image, and changing the background
color.
C H A P T E R
10-2—Complete this procedure as needed to
10-3—Complete this procedure as needed to
10-5—Complete this procedure as needed
10-6—Complete this procedure as needed
10-9—Complete this procedure as needed to modify
10-18—Complete this procedure as needed to change
10-26—Complete this procedure as needed to
Cisco ONS 15454 DWDM Installation and Operations Guide, R6.0
10
Chapter 3, "Turn Up a Node."
10-1