Ntp- G59 Create And Delete Optical Channel Network Connections - Cisco ONS 15454 DWDM Installation And Operation Manual

Chapter 7 Create Channels and Circuits
In the Circuits on Span dialog box, you can view information about the circuits that traverse the span.
The information that appears depends on the circuit type. For DWDM OCHNCs, the following
information appears:
•
•
•
•
Step 3 Return to your originating procedure (NTP).
NTP-G59 Create and Delete Optical Channel Network
Connections
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Complete the
Step 1
create and delete OCHNCs. If you are already logged in, continue with Step 2.
If you want to assign a name to the OCHNC source and destination ports before you create the circuit,
Step 2
complete the
Complete the
Step 3
as needed.
Complete the
Step 4
Stop. You have completed this procedure.
September 2005
OCHNC Wavelength—The wavelength provisioned for the OCHNC.
DIR—2-way or 1-way.
OCHNC Dir—The direction provisioned for the OCHNC, either east-to-west or west-to-east.
Circuit—The OCHNC circuit name.
This procedure creates and deletes DWDM OCHNCs.
None
Chapter 3, "Turn Up a Node"
As needed
Onsite or remote
Provisioning or higher
"DLP-G46 Log into CTC" task on page 2-25
"DLP-G104 Assign a Name to a Port" task on page
"DLP-G105 Provision DWDM Optical Channel Network Connections" task on page 7-10
"DLP-G106 Delete Optical Channel Network Connections" task on page 7-12
NTP-G59 Create and Delete Optical Channel Network Connections
at a node on the network where you want to
7-10. If not, continue with the next step.
Cisco ONS 15454 DWDM Installation and Operations Guide, R6.0
as needed.
7-9