Figure 3-17 Using The Patch-Panel Latches To Slide The Patch Panel Away From The Tray - Cisco ONS 15454 DWDM Installation And Operation Manual

Chapter 3 Turn Up a Node
Step 5 On the patch panel, pull up firmly on the two latches and use them to slide the patch panel up until it
snaps in place above the tray
Figure 3-17 Using the Patch-Panel Latches to Slide the Patch Panel Away from the Tray
Patch-panel
latches
At the 32WSS or 32MUX-O card in the node, plug the MPO connector of an MPO cable
Step 6
into the top Add RX (30.3–36.6) port of the card. If you are connecting to the next MPO cable, plug it
into the MPO connector below the previous MPO cable.
September 2005
DLP-G315 Install Fiber-Optic Cables From the 32WSS/32DMX and 32MUX-O/32DMX-O Cards to the Patch Panel
(Figure
Patch-panel
bar
MXP/TXP-DWDM
connections
3-17).
MPO fan-out connections
and slack
Cisco ONS 15454 DWDM Installation and Operations Guide, R6.0
Patch-panel
latches
(Figure 3-18)
3-75