Cisco ONS 15454 DWDM Installation And Operation Manual page 589

Change DWDM Card Settings
This chapter explains how to change line, performance monitoring (PM), and threshold settings on
Cisco ONS 15454 optical service, amplifier, multiplexer, demultiplexer, 32WSS, and AIC-I cards. To
install DWDM cards, see the
Unless otherwise specified, "ONS 15454" refers to both ANSI and ETSI shelf assemblies.
Note
Before You Begin
Before performing any of the following procedures, investigate all alarms and clear any trouble
conditions. Refer to the Cisco ONS 15454 Troubleshooting Guide or the Cisco ONS 15454 SDH
Troubleshooting Guide as necessary.
Changing card settings can be service affecting. You should make all changes during a scheduled
Caution
maintenance window.
This section lists the chapter procedures (NTPs). Turn to a procedure for applicable tasks (DLPs).
1.
2.
3.
4.
5.
6.
September 2005
NTP-G90 Modify OSCM and OSC-CSM Line Settings and PM Parameters and Thresholds, page
11-2—As needed, complete this procedure to change the OSCM and OSC-CSM card settings.
NTP-G91 Modify OPT-PRE and OPT-BST Line Settings and PM Parameters and Thresholds, page
11-12—As needed, complete this procedure to change the amplifier card settings.
NTP-G92 Modify 32MUX-O, 32DMX-O, 32DMX, and 4MD Line Settings and PM Thresholds,
page 11-23—As needed, complete this procedure to change the multiplexer and demultiplexer card
settings.
NTP-G93 Modify the 32WSS Thresholds and Settings, page
procedure to change the 32WSS card settings.
NTP-G101 Modify Alarm Interface Controller–International Settings, page
complete this procedure to change settings for external alarms, controls, and orderwire for the AIC-I
card.
NTP-G102 Change Card Service State, page
the card service state.
"NTP-G30 Install the DWDM Cards" procedure on page
11-45—As needed, complete this procedure to change
Cisco ONS 15454 DWDM Installation and Operations Guide, R6.0
C H A P T E R
11-33—As needed, complete this
11-42—As needed,
11
3-39.
11-1