Cisco ONS 15454 DWDM Installation And Operation Manual page 170

Hide thumbs Also See for ONS 15454 DWDM:
Table of Contents

Advertisement

DLP-G39 Set Up a Windows PC for Craft Connection to an ONS 15454 on the Same Subnet Using Static IP Addresses
i.
In the Subnet Mask field, type the same subnet mask as the ONS 15454. The default is
255.255.255.0 (24 bit).
Click OK.
j.
k.
In the TCP/IP dialog box, click the Gateway tab.
l.
In the New Gateway field, type the ONS 15454 IP address. Click Add.
Verify that the IP address appears in the Installed Gateways field, then click OK.
m.
When the prompt to restart your PC appears, click Yes.
n.
Proceed to
o.
If you have Windows NT 4.0 installed on your PC, complete the following steps to change its TCP/IP
Step 4
configuration:
From the Windows Start menu, choose Settings > Control Panel.
a.
In the Control Panel dialog box, click the Network icon.
b.
In the Network dialog box, click the Protocols tab, choose TCP/IP Protocol, then click Properties.
c.
Click the IP Address tab.
d.
In the IP Address window, click Specify an IP address.
e.
In the IP Address field, enter an IP address that is identical to the ONS 15454 IP address shown on
f.
the ONS 15454 LCD except for the last octet. The last octet must be 1 or 3 through 254.
In the Subnet Mask field, type 255.255.255.0.
g.
Click Advanced.
h.
In the Gateways List, click Add. The TCP/IP Gateway Address dialog box appears.
i.
Type the ONS 15454 IP address in the Gateway Address field.
j.
Click Add.
k.
Click OK.
l.
Click Apply.
m.
In some cases, Windows NT 4.0 prompts you to reboot your PC. If you receive this prompt, click
n.
Yes.
Proceed to
o.
If you have Windows 2000 installed on your PC, complete the following steps to change its TCP/IP
Step 5
configuration:
From the Windows Start menu, choose Settings > Network and Dial-up Connections >
a.
Local Area Connection.
In the Local Area Connection Status dialog box, click Properties.
b.
c.
On the General tab, choose Internet Protocol (TCP/IP), then click Properties.
Click Use the following IP address.
d.
In the IP Address field, enter an IP address that is identical to the ONS 15454 IP address shown on
e.
the ONS 15454 LCD except for the last octet. The last octet must be 1 or 3 through 254.
f.
In the Subnet Mask field, type 255.255.255.0.
In the Default Gateway field, type the ONS 15454 IP address.
g.
Click OK.
h.
In the Local Area Connection Properties dialog box, click OK.
i.
Cisco ONS 15454 DWDM Installation and Operations Guide, R6.0
2-12
Step
7.
Step
7.
Chapter 2
Connect the PC and Log into the GUI
September 2005

Advertisement

Table of Contents
loading

Table of Contents