Dlp- G318 Place Opt-Bst And Opt-Pre Ports In Service - Cisco ONS 15454 DWDM Installation And Operation Manual

DLP-G318 Place OPT-BST and OPT-PRE Ports In Service
Step 7 Under Admin State, choose OOS,DSBLD or Locked,disabled (ETSI) for each port that does not have
an OOS-MA,DSBLD or Locked,disabled service state.
Click Apply.
Step 8
Step 9 In the confirmation dialog box, click Yes.
Step 10 Return to your originating procedure (NTP).
DLP-G318 Place OPT-BST and OPT-PRE Ports In Service
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Step 1 On the shelf graphic in CTC, double-click the OPT-BST or OPT-PRE card with the ports that you want
to put in service.
Step 2 Click the Provisioning > Optical Line > Parameters tabs.
Step 3 Under Admin State, choose choose IS (ANSI) or Unlocked (ETSI) for Port 1 of the OPT-PRE or Ports
2 and 3 of the OPT-BST.
Click Apply.
Step 4
Step 5 In the confirmation dialog box, click Yes.
Step 6 Return to your originating procedure (NTP).
Cisco ONS 15454 DWDM Installation and Operations Guide, R6.0
12-4
This task places OPT-BST and OPT-PRE card ports in service.
None
DLP-G46 Log into CTC, page 2-25
As needed
Onsite or remote
Provisioning or higher
Chapter 12 Add and Remove Cards and Nodes
September 2005