Ntp- G37 Run Automatic Node Setup - Cisco ONS 15454 DWDM Installation And Operation Manual

Chapter 3 Turn Up a Node
The Import NE Update From File dialog box closes, and the MetroPlanner configuration settings are
imported.
Verify that the imported parameters are correct according to the printout of the MetroPlanner parameters
Step 7
file, then click Apply.
Stop. You have completed this procedure.
NTP-G37 Run Automatic Node Setup
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Complete the
Step 1
you are already logged in, continue with
Referring to the Cisco MetroPlanner Installation Parameters (see
Step 2
parameters that have a Yes in the Manually Set column. If there are no parameters that have a Yes in the
Manually Set column, continue with
In CTC, display the card where the parameter is to be provisioned in card view.
Step 3
Enter the specified Calibration parameter from the Cisco MetroPlanner Installation Parameters table.
Step 4
Click Apply.
Repeat Steps
Step 5
display Yes in the Manually Set field.
Change to node view.
Step 6
Click the Provisioning > WDM-ANS > Port Status tabs.
Step 7
Click Launch ANS.
Step 8
In the Apply Launch ANS dialog box, click Yes.
Step 9
In the Launch ANS confirmation dialog box, click OK.
Step 10
Step 11 Verify that one of the following statuses appears in the Link Status column for all ports:
•
•
•
If one of the following statuses is shown, complete the provided instructions:
September 2005
This procedure runs the CTC DWDM ANS function. ANS adjusts the
values of the variable optical attenuators (VOAs) to equalize the
per-channel power at the amplifier level.
The Cisco MetroPlanner Installation Parameters file
NTP-G36 Calculate Cable Connections, page 3-80
NTP-G138 Import a Cisco MetroPlanner Configuration File, page 3-82
NTP-G139 Verify Cisco MetroPlanner Reports and Files, page 3-3
Required
Onsite or remote
Superuser
"DLP-G46 Log into CTC" task on page 2-25
2 through 4 for all parameters in the Cisco MetroPlanner Installation Parameters table that
Success - Changed—The parameter setpoint was recalculated successfully.
Success - Unchanged—The parameter setpoint did not need recalculation.
Not Applicable—The parameter setpoint does not apply to this node type.
at the node where you want to run ANS. If
Step 2.
Step 6.
Cisco ONS 15454 DWDM Installation and Operations Guide, R6.0
NTP-G37 Run Automatic Node Setup
Table 3-1 on page 3-3), identify the
3-83