Dlp- G279 Change The Optical Line Rate - Cisco ONS 15454 DWDM Installation And Operation Manual

DLP-G279 Change the Optical Line Rate
DLP-G279 Change the Optical Line Rate
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
In node view, double-click the TXP or MXP card where you want to edit the PPM port rate.
Step 1
Click the Provisioning > Pluggable Port Modules tabs.
Step 2
Click the port with the port rate you that want to change in the Pluggable Ports area. The highlight
Step 3
changes to dark blue.
Click Edit. The Edit Port Rate dialog box appears.
Step 4
In the Change To field, use the drop-down list to select the new port rate and click OK.
Step 5
page 5-7
Step 6 Click Yes in the Confirm Port Rate Change dialog box.
Return to your originating procedure (NTP).
Step 7
DLP-G280 Delete a PPM
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
This task does not apply to the TXP_MR_10G card.
Note
In node view, double-click the TXP or MXP card where you want to delete PPM settings.
Step 1
Click the Provisioning > Pluggable Port Modules tabs.
Step 2
Cisco ONS 15454 DWDM Installation and Operations Guide, R6.0
5-8
This task edits PPM port rates for the TXP and MXP cards. Perform this
task if you want to change the port rate on a multirate PPM that is already
provisioned.
None
DLP-G277 Provision a Multirate PPM, page 5-3
DLP-G46 Log into CTC, page 2-25
As needed
Onsite or remote
Provisioning or higher
lists the available rates.
This task deletes PPM provisioning for SFPs or XFPs installed on TXP or
MXP cards.
None
DLP-G46 Log into CTC, page 2-25
DLP-G63 Install an SFP or XFP, page 3-45
DLP-G273 Preprovision an SFP or XFP Slot, page 3-46
As needed
Onsite or remote
Provisioning or higher
Chapter 5 Provision Transponder and Muxponder Cards
or
Table 5-1 on
September 2005