Chapter 8
Manage Alarms
b.
Return to your originating procedure (NTP).
Step 9
DLP-G123 Apply Alarm Profiles to Ports
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Note
You can also apply alarm profiles to cards using the
Nodes" task on page
Step 1
In node view, double-click the card that you want to change to open the card view.
Note
Click the Provisioning > Alarm Profiles > Alarm Behavior tabs.
Step 2
Figure 8-6
Inherited.
September 2005
•
Press the Ctrl key, and simultaneously left-click the node where the profile is to be saved.
If you do not want to save the profile to any nodes, click Select None.
•
If you want to update alarm profile information, click Synchronize.
•
Click OK.
This task applies a custom or default alarm severity profile to a port or
ports.
None
DLP-G121 Create a New or Cloned Alarm Severity Profile, page 8-17
DLP-G46 Log into CTC, page 2-25
As needed
Onsite or remote
Provisioning or higher
8-23.
The card view is not available for the TCC2/TCC2P card.
shows alarm profiles for the AD-1C card, for example. CTC shows Parent Card Profile:
"DLP-G124 Apply Alarm Profiles to Cards and
Cisco ONS 15454 DWDM Installation and Operations Guide, R6.0
DLP-G123 Apply Alarm Profiles to Ports
8-21