Chapter 13
Maintain the Node
Figure 13-6
Step 3
Attach the other end of the ground strap to the longer screw on the fiber guide.
a.
Attach the lock washer.
Attach the terminal lug.
b.
Using the open-end wrench, attach and tighten the #4 Kepnut (49-0337-01) on the terminal lug.
c.
Note
Replace the left cable-routing channel.
Step 4
Using a Phillips screwdriver, insert and tighten the screws for the cable-routing channel.
Step 5
Figure 13-7
September 2005
Installing the Door Ground Strap Retrofit Kit
To avoid interference with the traffic (line) card, make sure the ground strap is in a flat
position when the door is open. To move the ground strap into a flat position, rotate the
terminal lug counterclockwise before tightening the Kepnut.
shows the shelf assembly with the front door and ground strap installed.
Cisco ONS 15454 DWDM Installation and Operations Guide, R6.0
NTP-G40 Replace the Front Door
13-29