Cisco ONS 15454 DWDM Installation And Operation Manual page 594

DLP-G201 Change Optical Line Parameters for OSCM and OSC-CSM Cards
Table 11-2
Parameter
SES
SEFS
FC
UAS
Click Apply. If the change affects traffic, a warning message displays. Click Yes to complete the
Step 4
change.
Step 5 Return to your originating procedure (NTP).
DLP-G201 Change Optical Line Parameters for OSCM and OSC-CSM Cards
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Step 1 In node view, double-click the OSCM or OSC-CSM card where you want to change the optical line
parameters.
Click the Provisioning > Optical Line > Parameters tabs.
Step 2
Modify any of the settings described in
Step 3
options column in the table.
Table 11-3 OSCM and OSC-CSM Card Optical Line Parameter Settings
Parameter Description
Port # Displays the port number and TX or RX.
Port Name Provides the ability to assign the specified port a
name.
Cisco ONS 15454 DWDM Installation and Operations Guide, R6.0
11-6
OSCM and OSC-CSM Cards SONET Threshold Settings (continued)
Description
Severely errored seconds Numeric. Can be set for 15-minute or one-day intervals for
Severely errored framing
seconds
Failure count
Unavailable seconds
This task changes the optical line parameters for OSCM and OSC-CSM
cards.
None
DLP-G46 Log into CTC, page 2-25
As needed
Onsite or remote
Provisioning or higher
Options
Line or Section (Near and Far End). Select the bullet and click
Refresh.
Numeric. Can be set for Far End, for 15-minute or one-day
intervals for Section only. Select the bullet and click Refresh.
Numeric. Can be set for 15-minute or one-day intervals for
Line or Section. Select the bullet and click Refresh or Path
(Near and Far End).
Numeric. Can be set for 15-minute or one-day intervals for
Line or Section (Near and Far End). Select the bullet and click
Refresh.
Table 11-3. The provisionable parameters are listed in the
Options
Display only
User-defined. Name can be up to 32 alphanumeric/
special characters. Blank by default.
See the "DLP-G104 Assign a Name to a Port" task
on page 7-10.
Chapter 11 Change DWDM Card Settings
September 2005