Cisco ONS 15454 DWDM Installation And Operation Manual page 211

Chapter 3 Turn Up a Node
c. Click OK.
All OSPF areas must be connected to Area 0. If the ONS 15454 OSPF area is not physically connected
Step 7
to Area 0, use the following steps to create a virtual link table that will provide the disconnected area
with a logical path to Area 0:
Under OSPF Virtual Link Table, click Create.
a.
In the Create Virtual Link dialog box, complete the following fields. OSPF settings must match
b.
OSPF settings for the ONS 15454 OSPF area:
Click OK.
c.
After entering ONS 15454 OSPF area data, click Apply.
Step 8
If you changed the Area ID, the TCC2/TCC2P cards reset, one at a time. The reset takes approximately
10 to 15 minutes.
Return to your originating procedure (NTP).
Step 9
September 2005
• Range Address—Enter the area IP address for the ONS 15454 nodes that reside within the
OSPF area. For example, if the ONS 15454 OSPF area includes nodes with IP addresses
10.10.20.100, 10.10.30.150, 10.10.40.200, and 10.10.50.250, the range address would be
10.10.0.0.
• Range Area ID—Enter the OSPF area ID for the ONS 15454 nodes. This is either the ID in the
DCC OSPF Area ID field or the ID in the Area ID for LAN Port field.
Mask Length—Enter the subnet mask length. In the Range Address example, this is 16.
•
• Advertise—Check if you want to advertise the OSPF range table.
Neighbor—The router ID of the Area 0 router.
•
Transit Delay (sec)—The service speed. One second is the default.
•
Hello Int (sec)—The number of seconds between OSPF hello packet advertisements sent by
•
OSPF routers. Ten seconds is the default.
Auth Type—If the router where the ONS 15454 is connected uses authentication, choose
•
Simple Password. Otherwise, choose No Authentication.
Retransmit Int (sec)—Sets the time that will elapse before a packet is resent. Five seconds is the
•
default.
Dead Int (sec)—Sets the number of seconds that will pass while an OSPF router's packets are
•
not visible before its neighbors declare the router down. Forty seconds is the default.
Table 3-2 on page 3-14
DLP-G59 Set Up or Change Open Shortest Path First Protocol
shows the LED behavior during the TCC2/TCC2P reset.
Cisco ONS 15454 DWDM Installation and Operations Guide, R6.0
3-21