Dlp- G285 Add A Static Tid To Nsap Entry To The Tarp Data Cache - Cisco ONS 15454 DWDM Installation And Operation Manual

DLP-G285 Add a Static TID to NSAP Entry to the TARP Data Cache
•
•
•
•
•
Click Apply.
Step 3
Step 4 Return to your originating procedure (NTP).
DLP-G285 Add a Static TID to NSAP Entry to the TARP Data Cache
Purpose
Tools/Equipment
Prerequisite procedures
Required/As needed
Onsite/Remote
Security Level
In node view, click the Provisioning > OSI > TARP > Static TDC tabs.
Step 1
Click Add Static Entry.
Step 2
In the Add Static Entry dialog box, enter the following:
Step 3
•
•
Click OK to close the Masked NSAP Entry dialog box, if used, and then click OK to close the
Step 4
Add Static Entry dialog box.
Step 5 Return to your originating procedure (NTP).
Cisco ONS 15454 DWDM Installation and Operations Guide, R6.0
3-30
LDB Flush—Sets the frequency period for flushing the LDB. The default is 5 minutes. The range is
0 to 1440 minutes.
T1—Sets the amount of time to wait for a response to a Type 1 PDU. Type 1 PDUs seek a specific
NE TID within an OSI Level 1 area. The default is 15 seconds. The range is 0 to 3600 seconds.
T2—Sets the amount of time to wait for a response to a Type 2 PDU. TARP Type 2 PDUs seek a
specific NE TID value within OSI Level 1 and Level 2 areas. The default is 25 seconds. The range
is 0 to 3600 seconds.
T3—Sets the amount of time to wait for an address resolution request. The default is 40 seconds.
The range is 0 to 3600 seconds.
T4—Sets the amount of time to wait for an error recovery. This timer begins after the T2 timer
expires without finding the requested NE TID. The default is 20 seconds. The range is
0 to 3600 seconds.
The T1, T2, and T4 timers are not used if TARP PDUs Origination is not enabled.
Note
This task adds a static TID to NSAP entry to the TDC. The static entries are
required for NEs that do not support TARP and are similar to static routes.
For a specific TID, you must force a specific NSAP.
None
DLP-G46 Log into CTC, page 2-25
As needed
Onsite or remote
Provisioner or higher
TID—Enter the TID of the NE. (For ONS nodes, the TID is the Node Name parameter on the node
view Provisioning > General tab.)
NSAP—Enter the OSI NSAP address in the NSAP field or, if preferred, click Use Mask and enter
the address in the Masked NSAP Entry dialog box.
Chapter 3 Turn Up a Node
September 2005