Ntp- G54 Provision And Verify A Dwdm Network - Cisco ONS 15454 DWDM Installation And Operation Manual

NTP-G54 Provision and Verify a DWDM Network
NTP-G54 Provision and Verify a DWDM Network
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Step 1 Complete the
Step 2 Click the Alarms tab:
a.
b.
Using the Cisco MetroPlanner Traffic Matrix (see
Step 3
channel (ITU wavelength) to be provisioned. Use the transponder (TXP), MXP, or line card that
corresponds to the selected wavelength.
As needed, complete the
Step 4
optional step requiring data communications channel (DCC) connectivity between the node and
subtended client shelf or generic communications channel (GCC) connectivity between the TXPs.
Step 5 Create the optical channels at all sites according to the Cisco MetroPlanner Traffic Matrix. Complete the
"DLP-G105 Provision DWDM Optical Channel Network Connections" task on page
Note
Step 6 Select one of the nodes and go to node view.
Cisco ONS 15454 DWDM Installation and Operations Guide, R6.0
6-8
This procedure verifies the performance of all cable connections and cards
in a network topology. You can also use this procedure to troubleshoot any
problems with DWDM network setup.
Test set or protocol analyzer
Cisco MetroPlanner Traffic Matrix
DLP-G277 Provision a Multirate PPM, page 5-3
DLP-G278 Provision the Optical Line Rate, page 5-6
NTP-G96 Modify Line Settings and PM Parameter Thresholds for
TXP_MR_10G and TXP_MR_10E Cards, page 5-12
NTP-G97 Modify Line Settings and PM Parameter Thresholds for
MXP_2.5G_10G and MXP_2.5G_10E Cards, page 5-31
NTP-G98 Modify Line Settings and PM Parameter Thresholds for
TXP_MR_2.5G and TXPP_MR_2.5G Cards, page 5-48
NTP-G99 Modify Line Settings and PM Parameter Thresholds for
MXP_MR_2.5G and MXPP_MR_2.5G Cards, page 5-65
As needed
Onsite or remote
Provisioning or higher
"DLP-G46 Log into CTC" task on page 2-25
Verify that the alarm filter is not turned on. See the
page 8-28 as necessary.
Verify that no equipment (EQPT) alarms appear. If equipment failure alarms appear, investigate and
resolve them before continuing. Refer to the Cisco ONS 15454 Troubleshooting Guide or the
Cisco ONS 15454 SDH Troubleshooting Guide for procedures.
"DLP-G99 Create a Provisionable Patchcord" task on page
Every time a channel is created on the DWDM network, the amplifiers automatically calculate
the optical output power to maintain a constant power level on each channel. Automatic power
control (APC) also starts every 60 minutes. If the span length changes, APC modifies amplifier
gains and express variable optical attenuation (VOA). For more information about APC, see the
"18.4 Automatic Power Control" section on page
to log into an ONS 15454 on the network.
"DLP-G128 Disable Alarm Filtering" task on
Table 3-1 on page 3-3) for your site, identify the first
18-18.
Chapter 6 Turn Up Network
6-11. This is an
7-10.
September 2005