Ntp- G32 Install The Transponder And Muxponder Cards - Cisco ONS 15454 DWDM Installation And Operation Manual

Chapter 3 Turn Up a Node
NTP-G32 Install the Transponder and Muxponder Cards
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Warning During this procedure, wear grounding wrist straps to avoid ESD damage to the card. Do not directly
touch the backplane with your hand or any metal tool, or you could shock yourself. Statement 94
Class 1 laser product. Statement 1008
Warning
Warning Invisible laser radiation may be emitted from the end of the unterminated fiber cable or connector. Do
not view directly with optical instruments. Viewing the laser output with certain optical instruments
(for example, eye loupes, magnifiers, and microscopes) within a distance of 100 mm may pose an eye
hazard. Statement 1056
Caution Always use the supplied ESD wristband when working with a powered ONS 15454. Plug the wristband
cable into the ESD jack located on the lower-right outside edge of the shelf assembly.
Complies with the US Federal Drug Administration Code of Federal Regulations Title 21, Sections
Note
1040.10 and 1040.11, except for deviations pursuant to Laser Notice No. 50, dated July 26, 2001.
If protective clips are installed on the backplane connectors of the cards, remove the clips before
Note
installing the cards.
If you install a card incorrectly, the FAIL LED flashes continuously.
Note
Display Cisco MetroPlanner shelf layout (see
Step 1
the TXP and MXP cards.
September 2005
This procedure describes how to install the ONS 15454 TXP and MXP
cards.
TXP_MR_10G, TXP_MR_10E, TXP_MR_2.5G, TXPP_MR_2.5G,
MXP_2.5G_10G, MXP_2.5G_10E, MXP_MR_2.5G, and
MXPP_MR_2.5G cards (as applicable)
NTP-G15 Install the Common Control Cards, page 1-71
NTP-G14 Install DWDM Equipment, page 1-66
NTP-G139 Verify Cisco MetroPlanner Reports and Files, page 3-3
As needed
Onsite
None
Table 3-1 on page
Cisco ONS 15454 DWDM Installation and Operations Guide, R6.0
NTP-G32 Install the Transponder and Muxponder Cards
3-3) for the node where you will install
3-43