Dlp- G260 Clear A Manual Or Force Switch On A Node Timing Reference - Cisco ONS 15454 DWDM Installation And Operation Manual

Chapter 13 Maintain the Node
DLP-G260 Clear a Manual or Force Switch on a Node Timing Reference
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
In node view, click the Maintenance > Timing > Source tabs.
Step 1
Find the Clock reference that is currently set to Manual or Force in the Operation drop-down list.
Step 2
From the Operation drop-down list, choose Clear.
Step 3
Click Apply.
Step 4
Step 5 Click Yes in the confirmation dialog box. If the normal timing reference is an acceptable valid reference,
the node switches back to the normal timing reference as defined by the system configuration. If the
normal timing reference is invalid or has failed, a warning dialog box appears. Click OK; the timing
reference will not revert.
Step 6 Return to your originating procedure (NTP).
NTP-G113 View the ONS 15454 Timing Report
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Complete the
Step 1
timing status. If you are already logged in, continue with
Step 2 Click the Maintenance > Timing > Report tabs.
In the Timing Report area, you can view node timing information. The date and time of the report appear
Step 3
at the top of the report. The time stamp is the same as the alarms time stamp and can be configured using
the
describes the report fields and entries.
To update the report, click Refresh.
Step 4
September 2005
"DLP-G46 Log into CTC" task on page 2-25
"DLP-G118 Display Alarms and Conditions Using Time Zone" task on page
DLP-G260 Clear a Manual or Force Switch on a Node Timing Reference
This task clears a Manual or Force switch on a node timing reference
and reverts the timing reference to its provisioned reference.
None
DLP-G46 Log into CTC, page 2-25
As needed
Onsite or remote
Maintenance or higher
This procedure displays the current status of the ONS 15454 timing
references.
None
NTP-G53 Set Up Timing, page 6-4
As needed
Onsite or remote
Maintenance or higher
Cisco ONS 15454 DWDM Installation and Operations Guide, R6.0
at the node where you want to view the node
Step 2.
8-11. Table 13-2
13-19