Dlp- G301 Provision The Txp_Mr_10G And Txp_Mr_10E Trunk Port Alarm And Tca Thresholds - Cisco ONS 15454 DWDM Installation And Operation Manual

DLP-G301 Provision the TXP_MR_10G and TXP_MR_10E Trunk Port Alarm and TCA Thresholds
DLP-G301 Provision the TXP_MR_10G and TXP_MR_10E Trunk Port Alarm and
TCA Thresholds
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
In node view, double-click the TXP_MR_10G or TXP_MR_10E card where you want to change the
Step 1
trunk port alarm and TCA settings.
Step 2 Click the Provisioning > Optics Thresholds tabs.
Referring to
Step 3
Low, TX Power High, and TX Power Low.
Note
Note
Click Apply.
Step 4
Table 5-8
Card
TXP_MR_10G
TXP_MR_10E
Under Types, click the Alarm radio button and click Refresh.
Step 5
Referring to
Step 6
Low, TX Power High, and TX Power Low.
Note
Click Apply.
Step 7
Cisco ONS 15454 DWDM Installation and Operations Guide, R6.0
5-24
This task provisions the TXP_MR_10G and TXP_MR_10E trunk port
alarm and threshold crossing alert (TCA) thresholds.
None
DLP-G46 Log into CTC, page 2-25
As needed
Onsite or remote
Provisioning or higher
Table 5-8, provision the trunk port (Port 2) TCA thresholds for RX Power High, RX Power
You must modify 15 Min and 1 Day independently. To do so, choose the appropriate radio button
and click Refresh.
Do not modify the Laser Bias parameters.
TXP_MR_10G and TXP_MR_10E Trunk Port TCA Thresholds
TCA RX TCA RX
Power Low Power High
–22 dBm –8 dBm
–18 dBm –9 dBm
Table 5-9, provision the trunk port (Port 2) Alarm thresholds for RX Power High, RX Power
You must modify 15 Min and 1 Day independently. To do so, choose the appropriate radio button
and click Refresh.
Chapter 5 Provision Transponder and Muxponder Cards
TCA TX TCA TX
Power Low Power High
–1 dBm 7 dBm
0 dBm 9 dBm
September 2005